Oil Pan & Control Valve

REMOVAL

1. Raise and support vehicle.
2. Loosen and remove all but two oil pan bolts from front of case and drop rear edge of pan to drain fluid. Remove and clean pan and screen.
3. Unfasten and remove valve body.

INSTALLATION

1. Position valve body to case, making sure that selector and downshift levers are engaged, then install and torque attaching bolts to 95-125 inch lbs.
2. Using a new pan gasket, secure pan to case and torque bolts to 12 ft. lbs.
3. Lower truck and fill transmission to correct level with specified fluid.