Inspection

For additional information see Installation Notes. Fundamentals and Basics

Caliper Removal:

1. Install caliper slide pins through disc brake caliper and front wheel spindle. Lubricate slides with disc brake caliper slide grease. Position shoes onto spindle. Rotate caliper back up into position. If caliper was removed position it on the spindle. Install the anchor bolts through caliper and spindle. Tighten bolts to 115-135 Nm (85-100 lb ft).

Caliper Inlet Block:

2. If front brake hose was removed, replace both washers (each side of inlet block). Connect the front brake hose. Tighten inlet block bolt to 14-20 Nm (10-15 lb ft). Bleed the system.

3. Install wheel and tire assembly. Remove the safety stands and lower the vehicle.

4. If the brakes were not bled, and disc brake caliper was not removed check the fluid level in the brake master cylinder reservoir and fill if required.

5. Pump the brakes several times to make sure you get a firm brake pedal.

6. Operate the vehicle to check brake operation.