Rear Wiper Motor

REMOVAL AND INSTALLATION
1. Disconnect battery ground cable.
2. Remove wiper arm and blade assembly.

Fig. 10 Rear Wiper Motor Replacement:

3. Remove wiper motor shaft nut and wedge block, then the liftgate trim panel.
4. Disconnect electrical connector from wiper motor and motor wiring pins from inner panel, then remove wiper motor from vehicle.
2. Reverse procedure to install, noting the following:
a. Before installing wiper arm and blade assembly, cycle wiper motor to park position to ensure correct installation.
b. Torque pivot nut to 5 ft lb, then the bracket screws to 6 ft lb.