Front Blower Motor

REMOVAL AND INSTALLATION
1. Disconnect battery ground cable.
2. Remove air cleaner and/or air inlet duct, if necessary.
3. Remove vacuum reservoir to blower housing screws, then position reservoir aside.
4. Disconnect blower motor housing tube at blower motor, then remove blower motor to heater plenum chamber case screws and chamber.
5. Hold blower motor housing tube aside and pull motor from heater plenum chamber case.
6. Remove hub clamp from shaft, then pull blower motor wheel from shaft.
7. Reverse procedure to install.
8. When battery has been disconnected and connected, some abnormal drive symptoms may occur while the Powertrain Control Module (PCM) relearns it strategy. Vehicle may need to be driven ten miles or more to relearn strategy.