Heating and Ventilation System

REMOVAL PROCEDURE




1. Disconnect the negative battery cable.
2. Remove the audio system. Refer to Audio Systems.
3. Remove the lower left and the lower right HVAC controller retaining screws.
4. Remove the controller by pulling it out to provide clearance for the removal of the cable.




5. Disconnect the mechanical control cables by gently prying off the cable eyelet and unsnapping the cable housing from the mechanical slide.

IMPORTANT: Note the location of the cables and the housings to facilitate their reinstallation.

6. Disconnect the electrical connectors.

INSTALLATION PROCEDURE




1. Connect the electrical connectors to the proper sockets on the back of the controller.

2. Install the mechanical cable housings to the proper control positions.

3. Install the eyelets on the end of each cable, pressing each onto the proper post.

4. Install the controller by gently inserting the controller into the proper position on the center console.




5. Install the lower left and the lower right controller retaining screws.

Tighten
Tighten the HVAC controller retaining screws to 4 N.m (35 lb-in).

6. Install the audio system. Refer to Audio Systems.

7. Connect the negative battery cable.

8. Confirm the proper operation of the controller by moving it through all of the controller's possible functioning positions.