Drag Link - Installation

DRAG LINK - LHD





1. Clean any grease or debris from the tie rod ends, and the drag link attaching points (1).
2. Install the drag link and the attaching nuts (1) to the idler arm and pitman arm. Tighten the drag link nuts to 50 Nm (37 ft. lbs.).
3. Install the tie rod ends into the steering knuckles.
4. Install the nuts on the tie rod ends. Tighten to 50 Nm (37 ft. lbs.).
5. Install the steering dampener. Tighten to 40 Nm (29 ft. lbs.).
6. Adjust the front toe setting on the vehicle. Service and Repair.