Canister Purge Solenoid: Service and Repair

EVAPORATIVE EMISSION CANISTER PURGE SOLENOID VALVE REPLACEMENT

REMOVAL PROCEDURE




1. Remove the air cleaner outlet resonator.
2. Disconnect the evaporative emission (EVAP) canister purge solenoid valve tube (1) from the valve (2).




3. Disconnect the purge solenoid electrical connector (1).




4. Remove the purge solenoid nut.
5. Remove the engine wiring harness bracket from the stud.
6. Remove the purge solenoid stud.
7. Remove the purge solenoid from the intake manifold.

INSTALLATION PROCEDURE




1. Install the purge solenoid to the intake manifold.

NOTE: Refer to Fastener Notice.

2. Install the purge solenoid stud.

Tighten the stud to 12 N.m (106 lb in).

3. Install the engine wiring harness bracket to the stud.
4. Install the purge solenoid nut.

Tighten the nut to 12 N.m (106 lb in).




5. Connect the purge solenoid electrical connector (1).




6. Connect the EVAP canister purge solenoid valve tube (1) to the valve (2).
7. Install the air cleaner outlet resonator.