Engine Mount Replacement - Right

Engine Mount Replacement - Right Side

Removal Procedure





Notice: Refer to Engine Mounting Notice.

1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the starter.
3. Remove the engine mount to frame mounting bolts.





Notice: When raising or supporting the engine for any reason, do not use a jack under the oil pan, any sheet metal, or crankshaft balancer. Jacking against the oil pan may cause it to crack or break.

Important: Raise the engine only enough to permit removal of the engine mount.

4. Use a jack on the square tab at the rear of the engine block, and raise the engine, left side shown.




5. Remove the engine mount to engine mounting bolts.
6. Remove the engine mount from the vehicle.

Installation Procedure




1. Install the engine mount to the vehicle.

Notice: Refer to Fastener Notice.

2. Install the engine mount to engine mounting bolts.

Tighten the engine mount to engine mounting bolts to 50 N.m (37 lb ft).

3. Lower the engine.




4. Install the engine mount to the frame mounting bolts.

Tighten the engine mount to frame mounting bolts to 60 N.m (44 lb ft).

5. Install the starter.
6. Lower the vehicle.