Blower Motor Resistor Assembly

BLOWER MOTOR RESISTOR ASSEMBLY REPLACEMENT

REMOVAL PROCEDURE
1. Remove the right closeout/insulator panel.




2. Disconnect the blower motor resistor electrical connector (3).
3. Remove the blower motor resistor mounting screws (2).
4. Remove the blower motor resistor (1).

INSTALLATION PROCEDURE




1. Install the blower motor resistor (1).
2. Install the blower motor resistor mounting screws (2).

Tighten the screws to 1.9 N.m (17 lb in).

NOTE: Refer to Fastener Notice in Service Precautions.

3. Connect the blower motor resistor electrical connector (3).
4. Install the right closeout/insulator panel.