Wiper Motor Replacement

WIPER MOTOR REPLACEMENT

TOOLS REQUIRED
- J 39232 Wiper Transmission Separator
- J 39529 Wiper Transmission Installer

REMOVAL PROCEDURE




1. Remove the wiper arms.
2. Remove the air inlet grille panel.
3. Remove the transmission from the wiper motor drive link using the J 39232 .




4. Disconnect the electrical connector from the wiper motor.
5. Remove the three screws and wiper motor from the vehicle.

INSTALLATION PROCEDURE




1. Install the wiper motor onto the vehicle with three screws.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the wiper motor mounting screws to 6.5 N.m (57 lb in).

2. Connect the electrical connector.




3. Install the transmission drive link socket onto the crank arm ball of the wiper motor using the J 39529 .

IMPORTANT:
- Lubricate the socket with white lithium grease (GM P/N 9985885) or equivalent.
- The wiper transmission must be assembled to the crank arm past the second detent so the seal is compressed to a maximum height of 25.5 mm (1 in).

4. Install the air inlet grille panel.
5. Install the wiper arms.