Brake Pedal Assy: Service and Repair

Brake Pedal Assembly Replacement

Removal Procedure





1. Remove the booster pushrod (4) and stoplamp switch (2) from brake pedal (1). Refer to Stop Lamp Switch Replacement.
2. Remove the nut from the brake pedal pivot bolt.
3. Remove the brake pedal pivot bolt.
4. Remove the brake pedal (1), spacers and bushings from the vehicle.



Installation Procedure





1. Install the brake pedal (1) to the vehicle.
2. Install the through bolt, spacers and bushings to the vehicle.

Notice: Refer toFastener Notice in Cautions and Notices.

3. Install the nut to the brake pedal pivot bolt.

Tighten the nut to 45 Nm (33 lb ft).

4. Install the booster pushrod (4) and the stoplamp switch (2) to the brake pedal (1).