Flex Plate: Service and Repair

Engine Flywheel Replacement - Automatic Transmission

^ Tools Required
- J 44643 Flywheel Holding Tool
- J 45059 Angle Meter

Removal Procedure





1. Remove the transmission.
2. Install J 44643 in order to hold the flywheel.





3. Loosen the flywheel bolts.
4. Remove J 44643.
5. Remove and discard the flywheel bolts.
6. Remove the flywheel washer.

Caution: When removing, handling or installing this component wear protective gloves. The sharp edges on the component may be very sharp and may cause injury.

7. Remove the flywheel.
8. If required, clean and inspect the flywheel.

Installation Procedure

Caution: When removing, handling or installing this component wear protective gloves. The sharp edges on the component may be very sharp and may cause injury.





1. Install the flywheel.
2. Install the flywheel washer.

Notice: Refer to Fastener Notice in Service Precautions.

3. Install NEW flywheel bolts.





4. Install J 44643 in order to hold the flywheel.





5. Using the following steps and the sequence shown, tighten the bolts:
1. Tighten the bolts to 79 Nm (58 lb ft).
2. Tighten the bolts to 60 degrees using the J 45059.
3. Tighten the bolts again to 60 degrees using the J 45059.
6. Install the transmission.