Zone 8

1. Turn the steering wheel until the vehicle's wheels are pointing straight ahead.

IMPORTANT: Refer to SIR Service Precautions before disabling the SIR system.

2. Turn OFF the ignition.
3. Remove the key from the ignition.
4. Remove the trim panel.
5. Access the I/P module connector through the glove box.




6. Remove the SIR fuse from the fuse block (1) located in the underhood fuse block.

IMPORTANT: With the SIR fuse removed and the ignition ON, the AIR BAG indicator illuminates. This is normal operation and does not indicate an SIR system malfunction.




7. Remove the connector position assurance (CPA) (1) from the steering wheel module yellow 4-way connector (2) located left of the steering column near the knee bolster.
8. Disconnect the steering wheel module yellow 4-way connector located left of the steering column near the knee bolster.




9. Remove the CPA from the IP module yellow 4-way connector (1) located behind the IP support.
10. Disconnect the IP module yellow 4-way connector (1) located behind the IP support.




11. Remove the CPA from the RF side impact module yellow 2-way connector (1) located under the passenger seat.
12. Disconnect the RF side impact module yellow 2-way connector (1) located under the passenger seat.




13. Remove the CPA from the LF side impact module yellow 2-way connector (1) located under the driver seat.
14. Disconnect the LF side impact module yellow 2-way connector (1) located under the driver seat.