Front Suspension

Wheel Stud Replacement

Tools Required
^ J 43631 Ball Joint Remover

Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and the wheel.
3. Remove the rotor.





Important: Do not hammer on a wheel stud.

4. Remove the wheel stud bolt using J 43631.

Installation Procedure





1. Install the wheel stud to the wheel hub and bearing.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install 4 washers and the nut to the wheel stud.
Tighten the wheel stud nut to 130 Nm (95 ft. lbs.) drawing in the wheel stud.
3. Remove the nut and the washers.
4. Install the rotor.
5. Install the tire and the wheel.
6. Lower the vehicle.