Blower Motor Diode Assembly Replacement

Blower Motor Diode Assembly Replacement

Removal Procedure

1. Remove the IP bezel assembly screws.
2. Remove the IP bezel assembly.
3. Remove the radio. Refer to Radio Replacement Service and Repair in Entertainment.
4. Remove the HVAC control assembly screws.
5. Remove the HVAC control assembly.




6. Disconnect the blower motor diode assembly (3) from the wire harness.

Installation Procedure




1. Connect the blower motor diode assembly (3) to the wire harness.
2. Install the HVAC control assembly.

Notice: Refer to Fastener Notice in Cautions and Notices.

3. Install the HVAC control assembly screws.

Tighten the screws to 2 Nm (18 lb in).

4. Install the radio. Refer to Radio Replacement Service and Repair in Entertainment.
5. Install the IP bezel assembly.
6. Install the IP bezel assembly screws.

Tighten the screws to 2 Nm (18 lb in).