Blower Motor Resistor: Service and Repair

Blower Motor Resistor Assembly Replacement

Removal Procedure

1. Remove the IP storage compartment. Refer to IP Carrier Replacement Service and Repair in Instrument Panel, Gages, and Console.
2. Disconnect the electrical connectors.




3. Remove the blower motor resistor screws.
4. Remove the blower motor resistor.

Installation Procedure





Notice: Do not allow the resistor coils to touch. Improper operation or damage to the vehicle may result.

1. Install the blower motor resistor.

Notice: Refer to Fastener Notice in Cautions and Notices.

2. Install the screws.

Tighten the blower motor resistor screws to 1 Nm (9 lb in).

3. Connect the electrical connectors.
4. Install the IP storage compartment. Refer to IP Carrier Replacement Service and Repair in Instrument Panel, Gages, and Console.