Front

REMOVAL PROCEDURE




1. Remove the nuts located on the inside of the seat riser.
2. Remove the seat belt buckle from the floor stud by lifting upward on the seat. The seat does not have to be removed from the vehicle.
3. Disconnect the seat belt buckle warning lamp electrical connector.
4. Remove the seat belt buckle.

INSTALLATION PROCEDURE




1. Install the seat belt buckle.
2. Connect the seat belt buckle warning electrical connector.
3. Install the seat belt buckle to the floor stud.

NOTE: Refer to Fastener Notice in Service Precautions.

4. Install the nuts located at the base of the seat riser.

Tighten
Tighten the bucket seat to the floor to 35 N.m (26 lb ft).