Tie Rod End: Service and Repair

Tie Rod End Replacement - Outer

- Tools Required
- J 24319-B Universal Steering Linkage Puller

Removal Procedure





1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.
3. Remove the outer tie rod nut (1) from the knuckle (2).
4. Disconnect the outer tie rod end (3) from the steering knuckle (2) using the J 24319-B.





5. Place a match mark, using paint, on the inner tie rod thread (2) indicating the position of the tie rod lock nut (3).
6. Loosen the tie rod lock nut and remove the outer tie rod end (4) from the inner tie rod (1)

Installation Procedure





1. Install the tie rod lock nut (3) to the match mark on the inner tie rod (1). Do NOT tighten the lock nut.
2. Install the outer tie rod end (7) to the inner tie rod (1).

Notice: Refer to Fastener Notice in Service Precautions.

Important: When tightening the outer tie rod nut, support and push the outer tie rod end with a jack in order to prevent the ball stud from rotating.

3. Install the outer tie rod end (7) to the knuckle (5), and install the outer tie rod nut (4).

- Tighten the nut to 43 Nm (31.5 ft. lbs.).

4. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.





5. Measure the wheel alignment. Refer to Measuring Wheel Alignment.
6. Adjust the toe, if necessary. Refer to Front Toe Adjustment.

- Tighten the tie rod lock nut (2) to 65 Nm (47 ft. lbs.).

7. Lower the vehicle.