Canister Purge Solenoid: Service and Repair

REMOVAL PROCEDURE




1. Remove the engine sight shield.




2. Push the Evaporative Emission (EVAP) pipe connect fitting retainer inward.




3. Disconnect the EVAP pipe (2) from the EVAP purge solenoid (1).




4. Disconnect the EVAP purge solenoid electrical connector.
5. Remove the EVAP purge solenoid mount bolt (2).
6. Remove the EVAP purge solenoid (3) and the insulator (1) from the engine.

INSTALLATION PROCEDURE




1. Install the insulator (1) on the EVAP purge solenoid (3).
2. Install the EVAP purge solenoid (3) to the engine.

NOTE: Refer to Fastener Notice in Cautions and Notices.

3. Install the EVAP purge solenoid mount bolt (2).

Tighten
Tighten the EVAP purge solenoid mount bolt to 10.5 N.m (93 lb in)




4. Connect the EVAP pipe (2) to the EVAP purge solenoid (1).
5. Connect the EVAP purge solenoid electrical connector.




6. Install the engine sight shield.