Headlining Trim Panel Replacement (Pickup)

Headlining Trim Panel Replacement (Pickup)

Removal Procedure

1. Remove the IP top trim panel.
2. Remove the windshield pillar moldings.




3. Remove the drivers side accessory housing (1) from the IP.




4. Remove the IP upper brackets.
5. Remove the transfer case control module, if equipped.




6. Release the pressure on the headliner wire harness by removing the wire harness retainer (1) from the IP support beam.




7. Disconnect the headliner wire connectors from the junction block located next to the clutch or brake pedal.
8. Remove the wire harness retainers along the windshield pillar.
9. Follow the routing of the wire harness through the IP and release any wire harness retainers.
10. Carefully pull out the wire harness from the windshield pillar ensuring that the wire harness does not get caught on any part.
11. Remove the rear quarter trim panels, if necessary.
12. Remove the overhead console, if equipped.
13. Remove both front sunshades.
14. Remove the rear coat hook, if equipped.
15. Remove the interior dome lamp.
16. Remove the assist handles, if equipped.




17. Disengaging the front of the headliner from the roof.
18. If replacing the crew cab headliner remove the rear window from the vehicle. Refer to Rear Window Replacement (Pickup) Rear Window Replacement (Utility w/Cargo Door) in Heated Glass Element.
19. Remove the headliner from the vehicle by grasping the headliner on the left and the right sides near the front of the cab



Installation Procedure





1. With the aid of an assistant install the headliner to the vehicle.
2. Install the rear window into the vehicle, if removed.
3. Install the assist handles, if equipped.
4. Install the interior dome lamp.
5. Install the rear coat hook, if equipped.
6. Install both front sunshades.
7. Install the overhead console, if equipped.
8. Install the rear quarter trim panels, if needed.
9. Carefully route the wire harness through the IP in order to connect the wire to the junction block located next to the clutch or brake pedal.
10. Install the transfer case control module, if equipped.





Important: Ensure that all of the wire harness retainers in the IP and the windshield pillar are all pressed into place in order to prevent rattling during driving.

11. Press in the wire harness retainer (1) in order to secure the harness.




12. Connect the headliner electrical connector to the junction block located next to the clutch or brake pedal.





Notice: Refer to Fastener Notice in Service Precautions.

13. Install the IP upper brackets.

Tighten the IP upper brackets bolts to 9 N.m (80 lb in).

14. Connect the electrical connectors to the drivers side accessory housing (1).




15. Install the drivers side accessory housing (1) to the IP.
16. Install the windshield pillar moldings.
17. Install the IP top trim panel.