Blower Motor Resistor Replacement - Auxiliary (RPO C69)

REMOVAL PROCEDURE




1. Remove the left body side trim panel.
2. Remove the electrical connector.
3. Remove the screws that retain the resistor to the case.
4. Remove the blower motor resistor from the case.

INSTALLATION PROCEDURE




1. Install the blower motor resistor into the case.
2. Install the screws that retain the resistor to the case.

Tighten
Tighten the screws that retain the resistor to the case to 2 N.m (18 lb in).

3. Install the electrical connector.
4. Install the left body side rear trim panel.

For a description of the RPO Code(s) shown in this article/images refer to the RPO Code List found at Vehicle/Application ID RPO Codes