Turn Signal & Multifunction Switch

^ Tools Required:
- J 41352 Modular Column Holding Fixture

REMOVE OR DISCONNECT
1. Do steps 1 through 10, "Remove or Disconnect", LOWER SHROUD, UPPER SHROUD, in this section.





2. Two wire harness straps (22) from steering column wire harness.
3. Steering column bulkhead connector from vehicle wire harness.
4. Axial position assurance connector (23) from electrical (BTSI) actuator (61).
^ Electrical connector from (BTSI) actuator (61).
5. Grey and black connectors of turn signal & multifunction switch (24) from column bulkhead connector.
6. Two pan head tapping screws (13).
7. Turn signal & multifunction switch assembly (24) from column.

INSTALL OR CONNECT

NOTICE: Refer to the fastener NOTICE in Service Precautions. Failure to do so may result in component damage or malfunction of steering column.

1. Turn signal & multifunction switch assembly (24) to column.
^ With small blade screwdriver compress electrical contact and move multifunction switch (24) into position.
^ Electrical contact must rest on canceling cam assembly (6).
2. Two pan head tapping screws (13).
^ Tighten screws (13) to 7 Nm (62 lb in).

3. Grey and black connectors of multifunction switch (24) to column bulkhead connector.
4. Electrical connector to electrical (BTSI) actuator (61).
^ Axial position assurance connector (23).
5. Steering column bulkhead connector to vehicle wire harness.
6. Two wire harness straps (22) to steering column wire harness.
7. Do steps 4 through 15, "Install or Connect", LOWER SHROUD, UPPER SHROUD.