Extended Wheel Base

Adjustment Procedure

1. Remove the left or right rear quarter lower trim panel.
2. Disconnect the negative battery cable.

Important: Use only a 6-point 14 mm socket on the adjusting nut. The adjusting nut requires very little torque to achieve proper cable tension. Do not exceed 20 N.m of torque on the adjuster nut. Use of additional torque beyond 20 N.m may damage the adjuster nut. If the adjuster nut rounds, refer to Cable Tension Adjustment - Sliding Door (Extended - Alternate).

3. Position the sliding door center roller bracket at the front of the track. Ensure that the bracket is 25 mm (1 in) from the point where the cable tension adjuster nut is accessible in the adjuster window located on the motor clutch assembly.
4. Turn the 15 mm cable adjuster nut counter-clockwise until the tensioner pins are located between both the front and rear double blocks. The blocks are marked on the PSD module housing in order to adjust the cable tension. If the adjuster nut rounds, refer to Cable Tension Adjustment - Sliding Door (Extended - Alternate).

Installation Procedure

1. Connect the negative battery cable.
2. Perform the reinitialization procedure.
3. Install the left or right rear quarter lower trim panel