Housing End Plug Replacement

REMOVE OR DISCONNECT
^ Steering gear from vehicle.

DISASSEMBLE
^ Rotate stub shaft back and forth to drain fluid.

1. Retaining ring (1) by using a punch inserted into the housing access hole to unseat it.
2. Plug (2).
3. O-ring seal (3).

ASSEMBLE
^ Lubricate O-ring seal with power steering fluid.

1. O-ring seal (3) into housing (20).
2. Plug (2).
3. Retaining ring (1).
^ Install retaining ring (1) so that open end is approximately 25 mm (1 inch) from access hole in housing (20).

INSTALL OR CONNECT
^ Steering gear.