Steering Column Housing Assembly

Standard Steering Column:

Standard Steering Column - Legend:

^ Tools Required:
- J 23653-SIR Lock Plate Compressor
- J 41396 Park Lock Cable Pliers
- Or Equivalents

REMOVE OR DISCONNECT
1. Do all removal steps, Refer to Coil Assembly, Inflatible Restraint Steering Wheel.
2. Do removal steps 7 and 8, Refer to T/S & Multifunction Switch Assembly.
3. Do removal steps 2 through 6, Refer to Linear Shaft Assembly.
4. Do removal steps 2 through 6, Refer to Upper Column Housing Components.
5. Do removal steps 2 through 9, Refer to Lock Module Assembly.
6. Four torx(r) head screws (9). Steering column housing assembly (26).

INSTALL OR CONNECT

CAUTION: Always use the correct fastener In the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion Inhibitors) on threaded fasteners or fastener pint Interfaces. Generally, such coatings adversely affect the fastener torque and pint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these Instructions can help you avoid damage to parts and systems. Failure to do so may result in component damage or malfunction of steering column.

1. Steering column housing assembly (26).
2. Four torx(r) head screws (9).
Tighten screws (9) to 9.0 Nm (80 lb in).
3. Do installation steps 1 through 8, Refer to Lock Module Assembly.
4. Do installation steps 1 through 5, Refer to Upper Column Housing Components.
5. Do installation steps 1 through 5, Refer to Linear Shaft Assembly, and Adjust and Inspect.
6. Do all installation steps, Refer to Coil Assembly, Inflatible Restraint Steering Wheel.