Replacement

REMOVAL PROCEDURE
1. Remove the brake shoes.
2. Disconnect the brake pipe.
3. Remove the bolts.
4. Remove the wheel cylinder.





INSTALLATION PROCEDURE
1. Install the wheel cylinder.
2. Install the bolts.
^ Tighten the bolts to 13 Nm (115 inch lbs.).

NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems.

3. Connect the brake pipe to the wheel cylinder.
^ Tighten the brake pipe fitting to 22 Nm (16 ft. lbs.).

4. Install the brake shoes.
5. Bleed the brake system.