Wheel Cover: Service and Repair

REMOVE OR DISCONNECT

1. Tire and wheel assembly.
2. Place a block of wood approximately 50 mm (2 inch) in diameter with a squared off end against the back surface of the cap. A sharp hammer blow on the block of wood will remove the cap.

INSTALL OR CONNECT

NOTICE: Failure to hit the cap squarely without the load distributed evenly could result in permanent damage to the cap.

1. Place the cap into position at the wheel opening and place a block of wood at least 75 mm (3 inch) in diameter against cap face. Install the cap by striking the block of wood with a hammer.
2. Tire and wheel assembly.