Disc Backing Plate

REMOVE OR DISCONNECT
1. Brake caliper.

Note: Remove anchor bracket only if it is damaged or if rotor is being removed for refinishing or other service operations.

2. Anchor bracket bolts/screws.
3. Anchor bracket from mounting plate.
4. Parking brake cable, rear.
5. Rear parking brake shoe and lining.
6. Rear axle shaft.
7. Bolts/screws, nuts, and washers.
8. Mounting plate from axle housing.

INSTALL OR CONNECT
1. Position mounting plate to axle housing.
2. Bolts/screws, nuts, and washers.
^ Tighten mounting plate nuts to 65 Nm (47 ft. lbs.).
3. Rear Axle Shaft.
4. Rear parking brake shoe and lining.
5. Parking brake cable, rear.
6. Anchor bracket to mounting plate. Anchor bracket bolts/screws.
^ Tighten anchor bracket bolts/screws to 70 Nm (52 ft. lbs.).
8. Brake caliper.