On-Vehicle Service

^ Tools Required:
- J 25034-B Power Steering Pump Pulley Remover
- J 25033-B Power Steering Pump Pulley Installer
- Or Equivalents

REMOVAL

NOTE: Place a drain pan below the pump.

Remove or disconnect the following:
1. Air cleaner.
2. Upper fan shroud.
3. Drive belt.

Removing And Installing The Power Steering Pump Pulley:

4. Pulley.
- Install J 25034-B.
- Hold the nut. Turn the pilot bolt clockwise.
5. EVO actuator electrical connector.





6. Pump mounting nut and bolts.
7. Hoses from pump.
- Cap or plug to prevent fluid loss.
8. Pump.

INSTALLATION
Install or connect the following:
1. Pump.
2. Uncap and attach hoses to rear of pump. Tighten to 27 Nm (20 lb ft).
3. Pump mounting nut and bolts.
^ Tighten
- Bolts to 50 Nm (37 ft. lbs.).
- Nut to 41 Nm (30 ft. lbs.).
4. Pulley.
- Place the pulley on the end of the pump shaft.
- Install J 25033-b. Be sure the pilot bolt is bottomed in the shaft. Hold the pilot bolt.
- Turn the nut clockwise until pulley is seated.
5. EVO actuator electrical connector.
6. Drive Belt.
7. Upper fan shroud.
8. Air Cleaner.
- Fill and bleed the system. Service and Repair

INSPECT
Hoses for leaks and clearance.