Wheel Cover: Service and Repair

REMOVE OR DISCONNECT
1. Tire and wheel assembly.
2. Place a block of wood approximately 50 mm (2 inches) in diameter with a squared off end against the back surface of the hub cap. A sharp hammer blow on the block of wood will remove the hub cap.

INSTALL OR CONNECT

CAUTION: Failure to hit the cap squarely without the load distributed evenly could result In permanent damage to the cap.

1. Place the hub cap into position at the wheel opening and place a block of wood at least 75 mm (3 inches) in diameter against the hub cap face. Install the hub cap by striking the block of wood with a hammer.
2. Tire and wheel assembly.