Universal Garage Door Opener Programming Procedure

1. Hold down the two outside buttons on the "Universal Three Channel Garage Door Opener" until the red light begins to flash rapidly.
^ This procedure initializes the memory and erases any previous settings for all three channels.
2. Decide which of the three channels you want to program.
3. Hold the end of the hand held transmitter against the bottom surface of the universal transmitter (less than one inch) so you can still see the red light.
4. Simultaneously press the hand held transmitter button and the desired button on the universal opener.
^ Hold both buttons until you see the red light on the universal garage door opener flash rapidly. This could take up to a minute or more.
5. Release both buttons.
^ The universal garage door opener is now programmed.
^ Note to Canadian users: During programming, the customers hand-held transmitter may automatically stop programming after 1 or 2 seconds which may not be long enough to program the HomeLink TM transmitter. If you are programming with one of these transmitters, the right on the HomeLink TM transmitter may prompt you to reactivate the hand-held transmit ever with a series of double flashes. After the hand-held transmitter is reactivated, the light on the HomeLink TM transmitter will flash rapidly, indicating that it has been successfully programmed. If the light returns to a slow flash, reactivate the hand-held transmitter until the light flashes rapidly.
^ If the light does not perform as indicated, or the opener does not function properly, refer to System Diagnosis. Testing and Inspection