Installation Procedures

Rear Door Latch:

1. Install new latch assembly through the access hole.

2. Line up the latch assembly to door holes and install screws. Torque screws to 8-15 Nm (6-11 lb/ft).

3. Install upper and lower lock rods to the latch assembly. Push lock rods into the latch retaining holes. Pivot retaining clips onto lock rod assemblies.

Trim Panel:

1. Install trim panel to door.

2. Install and tighten trim panel screws.

3. Install the inside door handle cover (Figure 1, Item 4), inside door handle (Item 3), door handle screw (Item 2), and lock knob (Item 1).

4. Install Campaign Identification Label.