Axle Beam: Service and Repair

Support Replacement

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the rear tires and wheels.
3. Remove the exhaust pipe.
4. Disconnect the brake lines from the rear suspension support.
5. Disconnect the parking brake cables and tensioner from the suspension support.





Important: Support the rear suspension support with jack stands before removing the mounting bolts.

7. Remove the rear suspension support mounting bolts.
8. Remove the rear wheel spindle rods bolts from the knuckle.
9. Lower the rear suspension support in order to gain access to the rear wheel spindle rod bolts.
10. Remove the rear wheel spindle rods bolts from the rear suspension support.
11. Remove the rear suspension support.

Installation Procedure




1. Position the rear suspension support in place.

Notice: Refer to Fastener Notice.

2. Install the rear wheel spindle rod-to-rear suspension support bolts and nuts.

Tighten the nuts to 135 N.m (100 lb ft).

3. Install the rear suspension support mounting bolts.

Tighten the bolts to 110 N.m (81 lb ft).

4. Position the rear wheel spindle rod to the knuckle.
5. Install the retaining bolts and nuts to the knuckle.

Tighten the nut to 150 N.m (111 lb ft).

6. Install the stabilizer shaft to the rear suspension support.
7. Connect the brake lines to the rear suspension support.
8. Install the parking brake cables and the tensioner.
9. Install the exhaust pipe.
10. Install the tires and wheels.
11. Lower the vehicle.
12. Adjust the rear wheel alignment. Refer to Measuring Wheel Alignment.