Rear Suspension

Stabilizer Shaft Link Replacement

Removal Procedure

1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel assemblies.




3. Using a back-up wrench to prevent the link stud from rotating, remove the stabilizer shaft link nuts from the lower control arms.
4. Using a back-up wrench to prevent the link stud from rotating, remove the stabilizer shaft link nuts and links from the shaft.

Installation Procedure





Notice: Refer to Fastener Notice.

1. Using a back-up wrench to prevent the link stud from rotating, install the stabilizer shaft links and link nuts to the stabilizer shaft and to the lower crossmember.

Tighten the stabilizer shaft link nuts to 76 N.m (56 lb ft).

2. Install the tire and wheel assemblies.
3. Lower the vehicle.