Throttle Body: Service and Repair

THROTTLE BODY ASSEMBLY REPLACEMENT

REMOVAL PROCEDURE

NOTE:
- Do not use any solvent that contains Methyl Ethyl Ketone (MEK). This solvent may damage fuel system components.
- Do not use solvent of any type when cleaning the gasket surfaces on the intake manifold and the throttle body assembly, as damage to the gasket surfaces and throttle body assembly may result.

Use care in cleaning the gasket surfaces on the intake manifold and the throttle body assembly, as sharp tools may damage the gasket surfaces.

1. Remove the air cleaner resonator.
2. Disconnect the throttle body harness connector.




3. Remove the throttle body attaching bolts.
4. Remove the throttle body from the intake manifold.

INSTALLATION PROCEDURE




1. Inspect the throttle body gasket and replace if necessary.
2. Install the throttle body to the intake manifold.
3. Install the throttle body attaching bolts.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the throttle body attaching bolts to 10 N.m (89 lb in).

4. Connect the throttle body harness connector.
5. Install the air cleaner resonator.