Engine Mount Replacement

Engine Mount Replacement - Right

Removal Procedure
1. Disconnect the battery ground cable.
2. Remove the throttle body air inlet duct.
3. Remove the engine mount struts.
4. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
5. Remove the three-way catalytic converter pipe from the right rear exhaust manifold.
6. Remove the right front wheel and tire.
7. Remove the right engine splash shield.





8. Remove the engine mount lower nuts.
9. Raise the engine, using the universal engine support fixture.





10. Remove the bolts which secure the engine mount bracket to the oil pan.
11. Remove the engine mount and the engine mount bracket.





12. Remove the engine mount upper nuts.
13. Remove the engine mount from the engine mount bracket.

Installation Procedure





1. Install the engine mount to the engine mount bracket.

2. Notice: Refer to Fastener Notice in Service Precautions.

Install the engine mount upper nuts.
^ Tighten the upper nuts to 43 Nm (32 ft. lbs.).





3. Install the engine mount bracket with the engine mount to the oil pan.
4. Install the bolts which secure the engine mount bracket to the oil pan.
^ Tighten the bolts to 58 Nm (43 ft. lbs.).
5. Lower the vehicle.
6. Lower the engine.
7. Raise and suitably support the vehicle. Refer to Vehicle Lifting.





8. Install the engine mount lower nuts.
^ Tighten the lower nuts to 43 Nm (32 ft. lbs.).
9. Install the right engine splash shield.
10. Install the right front wheel and tire.
11. Connect the three-way catalytic converter pipe to the right rear exhaust manifold.
12. Lower the vehicle.
13. Remove the engine support fixture.
14. Install the engine mount struts.
15. Install the throttle body air inlet duct.
16. Connect the battery ground cable.