Telescope Motor

Telescope Motor Assembly Replacement

^ Tools Required
- J 41352 Steering Column Holding Fixture
- J 42640 Steering Column Anti Rotation Pin

Removal Procedure

1. Caution: Refer to SIR Caution in Service Precautions.

Disable the SIR system.
2. Remove the steering column.
3. Secure the steering column to J 41352.
4. Insert J 42640 into the bottom of the lower trim cover.





5. Disconnect the cable assembly (2) from the telescope drive motor assembly (1).





6. Remove the connector clip (1) from the telescope drive motor assembly connector (2).
7. Remove the 2 pan head tapping screws (4) from the telescope drive bracket (5).
8. Remove the telescope drive motor assembly (2) from the telescope drive bracket (5).
9. Remove the pan head tapping screw (3) from the telescope drive bracket (5).
10. Remove the telescope drive bracket (5) from the jacket assembly.

Installation Procedure





1. Install the telescope drive bracket (5) to the jacket assembly.
2. Install the pan head tapping screw (3) to the telescope drive bracket (5).

Notice: Install the guide retainer bolts.

^ Tighten the screw to 7 Nm (62 inch lbs.).
3. Install the telescope drive motor assembly (2) to the telescope drive bracket (5).
4. Install the 2 pan head tapping screws (4) to the telescope drive bracket (5).
^ Tighten the screws to 7 Nm (62 inch lbs.).
5. Install the connector clip (1) to the telescope drive motor assembly connector (2).





6. Caution: Refer to SIR Inflator Module Coil Caution in Service Precautions.

Connect the cable assembly (2) to the telescope drive motor assembly connector (1).
7. Remove the steering column from J 41352.
8. Install the steering column.
9. Enable the SIR system.