Weatherstrip Retainer Replacement - Lift Off Panel

Weatherstrip Retainer Replacement - Lift Off Panel

Removal Procedure




1. Remove the roof panel, place the roof panel upside down on a flat protective surface.
2. Remove the side weatherstrip.




3. Remove the screws attaching the retainer to the roof panel.
4. Remove the retainer.

Installation Procedure




1. Position the retainer to the roof panel, ensure that the molded end of the rubber is located towards the front of the roof panel.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the forward screw aligning the retainer fore and aft.

Important: Stripped, broken, or improperly seated screws must be replaced or repaired to prevent water leaks.

3. Install the remaining screws.

Tighten the side weatherstrip retainer screws to 3 N.m (27 lb in).

4. Install the roof panel.