Wiper Motor Crank Arm Replacement

WIPER MOTOR CRANK ARM REPLACEMENT

- J 39232 Wiper Transmission Separator
- J 39529 Wiper transmission Installer

REMOVAL PROCEDURE
1. Remove the air inlet grille panel.




2. Using the J 39232, disconnect the wiper transmission from the wiper motor crank arm.




3. Remove the wiper motor crank arm screw.
4. Remove the wiper motor crank arm from the wiper motor.

INSTALLATION PROCEDURE




1. Install the wiper motor crank arm onto the wiper motor.
2. Position the park latch 4 - 5 mm (0.16 - 0.20 in) from the park tab.




3. Install the wiper motor crank arm screw.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten
Tighten the screw to 15 N.m (11 lb ft).




4. Using the J 39529, connect the wiper transmission to the wiper motor crank arm.
5. Install the air inlet grille panel.
6. Inspect the wipers for proper operation.