Windshield Washer Reservoir: Service and Repair
WASHER SOLVENT CONTAINER REPLACEMENTREMOVAL PROCEDURE
1. Open the hood.
2. Drain the washer solvent from the washer solvent container.
3. Disconnect the washer solvent container level sensor electrical connector.
4. Remove the washer solvent container nuts.
5. Remove the heater hose retention clamp from the mounting stud.
6. Remove the washer solvent container from the mounting studs to gain access to the washer pump.
7. Disconnect the washer pump electrical connector.
8. Disconnect the washer pump hose.
9. Remove the washer solvent container from the vehicle.
INSTALLATION PROCEDURE
1. Position the washer solvent container to the vehicle.
2. Connect the washer pump hose.
3. Connect the washer pump electrical connector.
4. Install the washer solvent container onto the mounting studs.
5. Install the heater hose retention clamp onto the mounting stud.
6. Install the washer solvent container nuts.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the nuts to 8 N.m (71 lb in).
7. Connect the washer solvent container level sensor electrical connector.
8. Fill the washer solvent container with washer solvent.
9. Close the hood.
10. Inspect the washer system for proper operation.