Stoplamp Switch Replacement

REMOVAL PROCEDURE

Caution: Refer to Battery Disconnect Caution in Service Precautions.





1. Disconnect the negative battery cable.
2. Remove the knee bolster.
3. Remove the following components from the I/P carrier:
^ The plastic retainer
^ The left side air ventilation duct
^ The screw
^ The left side air outlet duct
4. Disconnect the stoplamp switch electrical connector.
5. Remove the following components from the vehicle:
^ One locknut
^ The stoplamp switch (1)

INSTALLATION PROCEDURE

Notice: Refer to Fastener Notice in Service Precautions.





1. Install the stoplamp switch (1) to the brake pedal bracket. Secure the stoplamp switch (1) using one locknut. Do not tighten.
2. Adjust the stoplamp clearance.
3. Tighten the locknut for the stoplamp switch.
^ Tighten the locknut to 10 Nm (89 inch lbs.).
4. Connect the stoplamp switch electrical connector.
5. Install the left side air outlet duct to the I/P. Secure the outlet duct with the screw.
6. Install the left side air ventilation duct to the I/P. Secure the ventilation duct with the plastic retainer.
7. Install the knee bolster.
8. Connect the negative battery cable.