Backup Lamp Switch Replacement

Removal Procedure
1. Remove the backup lamp switch electrical connector.
2. Remove the backup lamp switch wire from the retaining clamp.
3. Remove the backup lamp switch from the case.
4. Inspect the backup lamp switch O-ring for cuts or damage.
5. Replace the O-ring if necessary.

Installation Procedure

Notice: Refer to Fastener Notice in Service Precautions.

1. Install the backup lamp switch into the case.
^ Tighten the backup lamp switch to 23 Nm (17 ft. lbs.).
2. Install the backup lamp switch wire into the retaining clamp.
3. Install the backup lamp switch electrical connector (2).