Brake Modulator Assembly Replacement

REMOVAL PROCEDURE





1. Remove the air cleaner assembly.
2. Disconnect the EBCM harness connector (2).
3. Remove the 6 brake pipes from the valve assembly (3) for the brake pressure modulator.
4. Plug the brake pipes in order to prevent loss or contamination of brake fluid.
5. Remove 3 nuts and the brake pressure modulator valve assembly (3) from the bracket (4).

INSTALLATION PROCEDURE

Notice: Refer to Fastener Notice in Service Precautions.





1. Install the valve assembly (3) for the brake pressure modulator to the bracket (4). Secure with 3 nuts.
^ Tighten the brake pressure modulator valve assembly nuts to 21 Nm (15 ft. lbs.).
2. Remove the plugs from brake pipes and connect the brake pipes to the brake pressure modulator valve assembly (3).
^ Tighten the brake pipe fittings nuts to 15 Nm (11 inch lbs.).
3. Connect the EBCM electrical connector (2).
4. Install the air cleaner assembly.
5. Bleed the brake system.
6. Perform A Diagnostic System Check - ABS.