Installation Procedure

1. Install the driver seat belt buckle (6) to the vehicle.
2. Install the driver seat belt buckle (6) through the hole in the seat cushion on the split bench seat.

Notice: Refer to Fastener Notice in Cautions and Notices.

3. Install the driver seat belt buckle bolt (4).

Tighten
Tighten the driver seat belt buckle bolt to 42 N.m (31 lb ft).

4. Connect the following components if the components are disconnected:
^ The electrical connector (2)
^ The retainer (1)
Insert the connector under the carpet.
5. Install the driver seat belt buckle bolt plug (5) to the sleeve.