Vent Control Cables Replacement

Vent Control Cables Replacement

REMOVAL PROCEDURE

IMPORTANT: Note the routing of the cable to make installation easier.

1. Disconnect the fresh/recirc control cable (3) at the blower case (4).
2. Remove the heater control unit (5).
3. Disconnect the fresh/recirc control cable at the heater control unit.
4. Remove the fresh/recirc control cable from the Instrument Panel (IP).

INSTALLATION PROCEDURE
1. Position the fresh/recirc control cable (3) in the vehicle. Route the cable as previously noted.
2. Connect the fresh/recirc control cable to the heater control unit (5).
3. Install the heater control unit.
4. Connect the fresh/recirc control cable to the blower case (4).
5. Adjust the fresh/recirc control cable. Refer to Vent Control Cable Adjustment.