Power Steering Pump Flow Control Valve Replacement

DISASSEMBLY PROCEDURE





1. Remove the O-ring union fitting (5) from the housing (1).
2. Discard the O-ring seal (4) from the fitting (5).
3. Remove the control valve assembly (3) from the housing (1).
4. Remove the flow control spring (2) from the housing (1 ).

ASSEMBLY PROCEDURE





1. Install the flow control spring (2) to the housing (1).
2. Install the control valve assembly (3) to the housing (1).
3. Lubricate the O-ring seal (4) with power steering fluid.
4. Install the new O-ring seal (4) onto the O-ring union fitting (5).
5. Install the O-ring union fitting (5) into the pump housing (1).

NOTICE: Refer to Fastener Notice in Service Precautions.

- Tighten the union fitting (5) to 75.0 Nm (55 ft. lbs.).