Rear Floor, LH

REMOVAL PROCEDURE
1. Remove the console.
2. Remove the I/P accessory trim plate.
3. Remove the driver knee bolster trim panel.
4. Grasp the floor air outlet rear duct - LH and rotate 1/4 turn clockwise to release.
Carefully use a flat bladed screwdriver to release the duct, if necessary.
5. Remove the duct.

INSTALLATION PROCEDURE
1. Position the floor air outlet rear duct - LH in the same position in which it was released (1/4 turn above the installed position).
2. Insert and seat the duct into the HVAC module.
3. Rotate the duct 1/4 turn counterclockwise to secure.
4. Install the driver knee bolster trim panel.
5. Install the I/P accessory trim plate.
6. Install the console.