Parking Pawl: Service and Repair
Removal Procedure3T40 Transaxle
1. Raise the vehicle. Support the vehicle. Refer to Vehicle Lifting.
2. Remove the oil pan, the filter, and the seal. Refer to AT Fluid/Filter Changing.
3. Remove the transmission fluid level indicator stop bracket.
4. Remove the spring shaft retainer.
5. Remove the parking pawl actuator bracket.
6. Remove the clip.
7. Remove the manual shift shaft pin.
8. Remove the manual valve with the retainer rod.
9. Remove the manual valve pin.
10. Remove the parking pawl spring.
Installation Procedure
1. Install the parking pawl spring.
2. Install the manual valve pin.
3. Install the manual valve with the retainer rod.
4. Install the manual shift shaft pin.
5. Install the clip.
6. Install the parking pawl actuator bracket.
7. Install the spring shaft retainer.
8. Install the transmission fluid level indicator stop bracket.
9. Install the oil pan, the filter, and the seal.
10. Lower the vehicle.
11. Adjust the transmission oil level.
12. Inspect the shift linkage.