Generator Replacement

Generator Mounting:

REMOVE OR DISCONNECT
1. Negative battery cable.
2. Serpentine belt.

CAUTION: To avoid personal injury when rotating the serpentine belt tensioner on 2.4L use a tight fitting 13 mm wrench that is at least 61 centimeters (24 inches) long. This operation can be done using too J 3705g or equivalent.

3. Generator mounting stud and bolts.
4. Generator electrical connections.
5. Generator assembly.

INSTALL OR CONNECT
1. Generator assembly.
2. Generator electrical connections.
3. Generator mounting stud and bolts.
Tighten
^ Bolts and Stud to 50 N.m (37 lb ft).
4. Serpentine belt.
5. Negative battery cable.
Tighten
^ Bolt to 16 N.m (12 lb ft).