Transmission Case Removal

^ Tools Required:
- J 41099 Reverse Solenoid Socket
- Or Equivalent





1. Remove the computer aided gear select solenoid.





2. Remove the reverse lockout solenoid from the reverse lockout body. Use the J 41099.
3. Remove the reverse lockout assembly bolt and the reverse lockout body.





4. Remove the shifter cover plate retainer bolts.
5. Remove the shifter cover plate.
6. Remove the shift detent assembly.





7. Remove 8 of these adapter plate to transmission case bolts.
8. Rotate the transmission into the vertical position.





9. Remove the last 2 adapter plate to transmission case bolts.
10. Remove the shift lever guide bolts.





11. Remove the magnets from the transmission case.





12. Remove the offset lever roll pin.





13. Remove the transmission case and the offset lever together as follows:
a. Slide the transmission case up and off of the gear clusters and the shift shaft components.
b. Hold the offset lever against the guide plate in order to prevent the release of the detent ball and the spring.
c. Remove the offset lever from the transmission case.